Converting Your Campfire To A Different Gas Type - WLee OUTDOOR FIREPIT FOR PROPANE AND NATURAL GAS Owner's Manual

CONVERTING YOUR CAMPFIRE TO A DIFFERENT GAS TYPE

To convert your Campfire from propane to natural gas or natural gas to propane gas, carefully follow the steps below:
1. MAKE SURE THAT THE GAS SUPPLY TO THE CAMPFIRE (AND ANY NEARBY ELECTRICAL
SOURCES/APPLIANCES) ARE SHUT OFF.
2. Remove all logs and lava rock from the Campfire enclosure and remove the decorative top.
3. Remove the 4 screws attaching the burner pan to your fire ring or enclosure.
4. Carefully detach the connector hose attached to the orifice holder (Figure # 1) and unscrew the orifice holder
from the burner pipe (Figures #1 and # 2).
5. Remove the orifice from the holder (Figure # 2 ) and replace it with the proper sized one for your gas
requirement. Propane requires the smaller orifice.
6. If you are converting to propane (LP) gas, slide the air shutter so that the air intake hole is open (Figure #1). For
natural gas, slide the air shutter so that the air intake hole is closed (Figure #2).
Burner
Air shutter closed for
MANUFACTURER'S USE ONLY
Quality Check
Orifice # (MAIN) ____________
Orifice # (OTHER) ____________
Leak Test: ____________
Burn Test: ____________
Gas Type:
Open air shutter
Air intake hole open for
LP Gas
Orifice
Natural Gas
LP / NAT
Orifice holder
Connector hose
Figure 1
Orifice holder
Connector hose
Figure 2
Model #
Serial #
Air Shutter:
Inspector:
8
Date:____________
____________
____________
____________
____________
Rev 01- 8/07