Table of Contents
Advertisement
INSTALLATION PREPARATION
TRANSDUCER EXCHANGE
Other transducers are available as replacements for the standard transducer.
You may exchange your new and unassembled transducer for another type by
returning it to the address listed in Customer Support. Some transducers may
have additional cost. Refer to the Accessory catalog or call Customer Support for
information.
BEGINNING INSTALLATION
Now that you have determined the transducer mounting method you can begin
installation of your new Humminbird fishfinder. The installation guide included on
the next few pages provides detailed step by step instructions for installation of
the control head and transducer. For transom mount transducer installations you
will need the mounting template included with your manual.
In addition to the parts included you need the following for installation and
operation:
A powered hand drill and various drill bits
Philips and flat-head screwdrivers
A ruler or measuring tape
Pen or pencil
12 volt power source (your boat's battery)
A 1-amp fuse
A fuse holder (if you are wiring directly to the boat's battery)
Silicone sealant (for sealing drilled holes)
2-part, slow-cure epoxy (for inside the hull transducer installations)
TRANSDUCER EXCHANGE
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Wide 3D View and is the answer not in the manual?
Questions and answers
Gibt es noch Ersatzteile ,brauch den Geber für das wasser
The manual mentions that Humminbird offers a wide assortment of accessories to expand the capability of the fishfinder. These accessories are available through Humminbird dealers or directly from the factory. While it does not explicitly state that replacement transducers are available, it is likely that they can be obtained as part of the accessories catalog.
This answer is automatically generated