Charging Indications; Troubleshooting - PRO Charging System i2412 Safety, Installation And Operating Instructions

Ne jamais fumer près de la batterie ou du moteur et éviter toute étincelle ou flamme nue à proximité de ces dernie.
Working in the vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases
during normal operation. For this reason it is of the utmost importance that prior to each use of your charger, you
read and follow the instructions provided exactly.
Il est dangereux de travailler a proximité d'une batterie au plomb. Les batteries produisent des gaz explosifs en service
normal. Il est aussi important de toujours relire les instructions avant d'utiliser le chargeur et de les suivre à la lettre.

CHARGING INDICATIONS

When your battery charging system is activated, the battery status indicator provides charging information utilizing five red
LED indicators and one green LED indicator.
Indications are as follows:
ST
1 RED LED . . . . . . . . . . . . . . Illuminated configured for Wet Cell and AGM batteries
ND
2 RED LED . . . . . . . . . . . . .
RD
3 RED LED . . . . . . . . . . . . .
RD TH
3 & 4 RED LEDS . . . . . . . Charging - 60% Complete
RD TH TH
3 , 4 & 5 RED LEDS . . . . Charging - 90% Complete
BLINKING GREEN LED . . . .
STEADY GREEN LED . . . . . . Charge Complete - Monitoring Batteries
The green LED is illuminated whenever the charge cycle has terminated and the internal circuitry has determined the
batteries to be fully charged. The green LED will blink during the finishing stage of the charge cycle. After the completion of
the charge cycle, the green LED will remain on steady during the float-maintenance stage.

TROUBLESHOOTING

PROBLEM: No LED indicators illuminated on battery status indicator.
Solution Sequence:
1. Confirm that current is being delivered to the charger. Use a meter or test light to check the AC power supply from its
source through all connecting points up to the charger.
2. Check that the AC circuit breaker (on front of the unit) is depressed.
3. Call technical support for further assistance (800.742-2740).
PROBLEM: The charge status indicator changes rapidly back and forth from red to green or the green LED will not
illuminate after excessive charging time (24 hours or more).
Solution Sequence:
1. Disconnect AC power from the charging system. This indication may signify a possible battery problem.
2. Call technical support for further assistance (800.742.2740).
PROBLEM: A green LED was illuminated before disconnecting the power from the charger, but upon reconnection,
red LEDs appear and remain on.
Battery Type Indicators
Two red LED indicators are provided in order to display what type of battery the
charger has been programmed to charge.
Battery System Percent Charged Indicators
Four LED indicators are provided in order to display the progress of the charge cycle
in percentage of charge.
Illuminated configured for Gel Cell batteries
Charging - Initial Charging Up To 30%
Finishing Stage
6