Table of Contents
Advertisement
Quick Links
Safety, Installation and Operating Instructions
Manual for the Following Battery Charger Models
________________________________________
IMPORTANT NOTICE:
Please save and read these safety, operating and installation instructions before installing or applying AC power
to your Pro Charging Systems (PCS) charger. Contact technical support at PCS with any product, installation, or
service questions (800.742.2740).
Instructions importantes concernant la sécurité
i2412, i3612, i4809, i2425, i3625, and i4818
Pro Charging Systems, LLC
LaVergne, TN 37086-3539
081808
Advertisement
Table of Contents
Related Manuals for PRO Charging System i2412
Summary of Contents for PRO Charging System i2412
- Page 1 Safety, Installation and Operating Instructions Instructions importantes concernant la sécurité Manual for the Following Battery Charger Models i2412, i3612, i4809, i2425, i3625, and i4818 ________________________________________ 081808 IMPORTANT NOTICE: Please save and read these safety, operating and installation instructions before installing or applying AC power to your Pro Charging Systems (PCS) charger.
-
Page 2: Table Of Contents
INSTRUCTIONS FOR THE FOLLOWING BATTERY CHARGER MODELS: For lead-acid batteries with capacities of 70 to 260 ampere-hours (20 HR rating): MODEL AC Supply DC Output Battery System i-2412 120 volts, 60 Hertz 12 amps @ 24 volts 24 volt, 12 cell, series connected i-3612 120 volts, 60 Hertz 12 amps @ 36 volts... -
Page 3: Personal Safety Precautions
PERSONAL SAFETY PRECAUTIONS Always read all instructions before using your charger! 1. Wear complete eye protection and clothing protection. Avoid touching eyes while working near battery. Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, eyes, or other surfaces. If battery acid contacts skin or clothing, wash immediately with soap and water. -
Page 4: Installation And Preparation
INSTALLATION AND PREPARATION To reduce risk of battery explosion, follow these instructions, those published by the battery manufacturer, and by the manufacturer of any equipment that you intend to use in the vicinity of battery. Review all cautionary markings on these products and on the engine. Pour réduire le risque d’explosion, lire ces instructions et celles qui figurent sur la batterie. - Page 5 Utiliser le chargeur pour charger une batterie au plomb uniquement. Ce chargeur n’est pas concu pour alimenter un réseau électrique très basse tension ni pour charger des piles sèches. Le fait d’utiliser le charger des piles sèchespourait entrainer l’éclatement des piles et causer des blessures ou des dommages. DO NOT attempt to attach a charger to a battery pack if the output of the charger does not match the battery pack voltage.
-
Page 6: Charging Indications
Ne jamais fumer près de la batterie ou du moteur et éviter toute étincelle ou flamme nue à proximité de ces dernie. Working in the vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal operation. For this reason it is of the utmost importance that prior to each use of your charger, you read and follow the instructions provided exactly. -
Page 7: Led Fault Code Indications
This is the normal operating procedure for the system. It indicates that a reanalysis of the battery status was initiated and after a series of steps the green LED will illuminate. LIGHT EMITTING DIODES (LED) FAULT CODE INDICATIONS The microprocessor is constantly monitoring the charger circuitry and will both detect and display blinking LED indications if a fault is detected. -
Page 8: Additional Products
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Please call Pro Charging Systems, LLC for full warranty information and/or service please call (800.742.2740). Below are some of our other options in chargers and battery accessories. Call our technical support group for more detailed information or visit our web site www.dualpro.com.