Table of Contents
Advertisement
11. AUTO CALIBRATION
11.1 Overview
Autocal(Auto Calibration) is the PC side Calibration tool that perform Tx, Rx and Battery
Calibration with Agilent 8960(GSM call setting instrument) and Tektronix
PS2521G(Programmable Power supply).
Autocal generate calibration data by communicating with phone and measuring equipment then
write it into calibration data block of flash memory in GSM phone.
11.2 Requirements
- PC or Notebook installed with Microsoft Windows 98/ME/2000/XP
- Auto Calibration program(Autocal.exe)
- GSM Phone
- LGE PIF JIG, Serial Cable, Data Cable
- Agilent 8960(Call Setting Instrument)
- Tektronix PS2521G(Programmable Power Supply)
11.3 Menu and Settings
- File(F) Clear View
- File(F) Save View
- File(F) Save Setting
- File(F) Load Setting
- File(F) Make BIN ALL
- File(F) Make BIN BAT.Cal only : Make binary file of battery cal data only after calibration
- File(F) Make & Write BIN
- View(V) Tools
- View(V) Status
- Connection(C) Connect
- Connection(C) Port Setting
- GPIB(G) Connect
: Clear Calibration Status window texts
: Save Calibration Status window texts
: Save Current Calibration settings to setting file( * .cal)
: Load saved Calibration setting
: Make binary file after calibration finished
finished
: Make binary file after calibration finished then download it to
the Flash Memory
: Enable or disable Tool bar
: Enable or disable status bar
: Connect the phone with PC. This procedure checks whether
the PC is connected "ag8960" or not. After that it performs
sync. procedure withphone. If the sync. procedure is
successful state column on status bar changed to SETUP, else
you should disconnect phone and try again from the beginning
and also check the whole connection. All measurement is
performed at state SETUP.
: Show COM port setting dialog and Baudrate you can change,
etc.
: Connect the Ag8960 GPIB card with PC.
- 117 -
11. AUTO CALIBRATION
Advertisement
Table of Contents
