Interconnections - Ahuja DFX-16 Operation Manual

The effects processor can be used
as a table top unit. The unit should
be situated so that its location or
position does not get affected by
the heat of the amplifier.
The effects processor must always
be powered through a 9V AC
adaptor supplied alongwith.
Always insert the AC adaptor plug
into the 9V AC power socket of the
unit and then connect the AC
adaptor to an AC mains outlet.
When foot switch is to be used,
always connect the foot switch to
the bypass jack socket of the
9V AC Adaptor
ZONE-A ZONE-A
BTZ-7000
SSA-250M
DFX-16 (Rear Panel)
BYPASS
9 VAC~
POWER
LEFT
Foot Switch
BTZ-7000
Aux Input
Line Input
SSA-250M

• Interconnections

effects processor before the power
is turned ON.
To avoid signal overloading,
distortion and to minimize the
noise, it is necessary to set the
proper signal levels at every point
in the send / return chain.
The connection diagrams that
follow display the typical types of
input sources and output
equipments which can be
connected to the effects processor.
For correct connections and
operation, check the specification
of the connected equipment.
OUTPUT INPUT
RIGHT LEFT (MONO)
Mic-1 Mic-1
Return Send
PSX-1200
7
RIGHT
Preamp
Output
Aux Send (Post Fade)
Aux Return
Mixing Console
MX-15
MX-15
P r o S e r i e s
A M X - 1 6 1 2