Function Setting - Vane Angle Control
This function is to adjust airflow angle.
• While adjusting the vane angle, a command from central controller, wireless remote con-
troller or dry contact, etc shall not be reflected in the system for 1 minute.
OPERATION INSTRUCTION
Repeat pressing
1
icon flash.
Press
button to select active vane :
2
1 / 2 / 3 / 4 / All / Standard
Select Vane number using
❈ Vane number : No. 1, 2, 3, 4, all, or
standard
- Selected vane is in operation.
- Please verify the operating vane.
- To set the angle of all the vanes,
select 'all'.
- To set as the factory default settings,
select 'standard'.
Select wind angle using
3
and press
button.
- The boundary of wind angle settings can
be changed to 5 levels or 6 levels
according to the product.
- When selecting 'standard' for Vane
number, the wind angle does not move.
Set the wind angles for the remaining
4
vanes as the same as above.
❈ There are products with vanes with
no. 1 and no. 2 only according to the
product types.
5
Press
button to complete and
active the setting process.
(Airflow direction function will be
released whenever setting vane angle)
Press
button to exit.
6
❈ After setup, it automatically gets
out of setup mode if there is no
button input for 60 seconds.
❈ When exiting without pressing set button,
the manipulated value is not reflected.
27
button until
buttons.
button,