Listen To Radio - Philips Home Theater System User Manual

Tip
•
For better FM stereo reception, connect an external
FM antenna (not supplied).
•
Position the antenna as far away as possible from
your TV, VCR or other radiation source to prevent
interference.
First time tuning
When you access radio mode for the fi rst
time, follow the instructions to install the radio
stations.
1
Press RADIO .
'AUTO INSTALL ... PRESS PLAY' is
»
displayed.
2
Press .
All detected radio stations are stored.
»
Once complete, it tunes to the fi rst
»
preset radio station.
• To stop auto tuning, press
Note
•
This Home Theater System can store up to a
maximum of 40 radio stations.
•
If auto installation is not activated or less than 5 radio
stations are stored, you will be prompted to install
the radio stations again.

Listen to radio

1
Press RADIO .
2
Use the remote control to control the
radio.
Button Action
Selects a preset radio station.
Tunes the radio frequency up or
down.
Press and hold this button to
erase the current radio station
from the preset list.
The preset number for other
radio stations remain unchanged.
EN
22
Reinstall all the radio stations
1
2
•
Check the radio antenna connection if no stereo
signal is detected or less than 5 stations are detected
during radio installation.
Search and store radio stations
individually
1
2
.
3
4
5
6
Press RADIO .
Press and hold PROGRAM for more than
5 seconds.
All previously stored radio stations are
»
replaced.
Note
Press RADIO .
Press / .
It starts searching until a radio station
»
is detected.
Repeat step 2 until you tune to the radio
station you wish to store.
• To fi netune the radio frequency,
press / .
Press PROGRAM .
The preset station number blinks.
»
If no action is carried out within 20
»
seconds after the above step, it exits
the preset mode.
Press / (or the Numeric buttons ) to
select a preset number to store.
Press PROGRAM to confi rm.