Tecsun PL-380 Operation Manual page 7

select the FM frequency.
2.) Press & hold [FM] button until digital number is running, this radio would search &
stored the available radio stations automatically.
3.) After finished the ATS operation, turn the [TUNING] knob to select the radio station
MW, LW or SW ATS are same as the FM ATS.
Special note: There are mode A & mode B for ATS in SW.
Mode A : Auto-searching & storing all the radio stations within all meter bands.
Mode B: Auto-searching & storing all the radio stations within present meter band only.
.
Special note:
During ATS process in FM / MW / LW & SW mode A, pre-stored radio stations will be
deleted & covered automatically by the new searched stations. If ATS is interrupted or
being turned off during process, for those radio stations without deleted & covered by ATS
would still be kept.
With ATS in SW mode B, those existing memories will not be deleted & covered; all the
newly found radio stations would be stored in the blank memories addresses.
Storing frequencies into memory
1. Turn on your radio, and tune into your favorite station.
2. Short press [M] button, with the memory address is flashing in the display, press [M]
button again to confirm.
Listen to stations in the memory
1. Turn on the radio, press and release the [VM] button with notice that the PRESET
stations show in the display's upper right corner.
2. Turn the [TUNING] knob to selected stored stations.
Delete memory
1. Turn on the radio and press the [VM] button, causing PRESET stations to appear in the
display's upper right corner.
2. Use the [TUNING] knob to select the memory that you want to delete.
3. Long press [DELETE] button. " DEL " is flashing in the display, press [DELETE] button
again to confirm it.
Auto browse stations
1. Turn on the radio and press the [VF] button with notice that Frequency flashes.
2. Long press [FM] button to search for those available stations. Auto search will stop on
each available station for 5 seconds before it goes on searching for the next available
station.
3. To stop auto search function, simply press [VF] button again.
Auto browse memory
1. Turn on the radio, press the [VM] button to switch to memory
address status.
2. Long press [VM] button and it will search all the stations within
the memory, and stop on each station for 5 seconds.
www.tecsunradio.com hch@cantonmade.com