Auto On / Off Function; Set The Alarm By Radio; Set Alarm By Buzzer; Snooze - Tecsun PL-380 Operation Manual

duration flashing. Rotate the [TUNING] knob to select 1 ~ 90 minutes of the alarm's
duration.
4. Finally, short press [ALARM] button again with a long "B--" sound to confirm.
Note: If [ALARM] button not to be pressed again within 3 seconds for confirmation, it will
auto confirm the present display time and following with a long "B" sound.
Auto alarm on / off function
There are two kinds of alarm sounds (buzzer & radio) for selection. You could also select
the time for auto turn off from 1 – 90 minutes once the alarm has been activated.
Select the alarm by radio " " or by buzzer " "
1. To activate the alarm by radio, short press [ALARM] button with a "B" sound and
notice that the " " symbol shows up in the Timer display section.
2. To activate the alarm by buzzer, short press [ALARM] button again with a "BB" sound
and notice that the " " symbol appears in the Timer display section.
3. Short press [ALARM] button again with a long "B--" sound and notice nothing appears
in the Timer display section to turn off the alarm.

Set the alarm by radio

1. Turn on the radio, tune into your favorite alarm radio station. Please set the volume at
the noticeable level.
2. Short press [M] button with a "B" sound and short press [ALARM] button at once with a
"B" sound while " " symbol is flashing for couple seconds. Now this alarm radio station
is set.
Special Note :
1.) The selected radio station for alarm is still being stored in memory, even if the
ATS process completed. It is only to be removed by setting alarm with another
radio station again.
2.) In case of alarm being activated during your listening of the radio, it will switch
to the radio station which was set for alarm function.
3.) Please check the volume is at the right level after alarm is set.

Set alarm by buzzer

If you don't know the broadcasting time & frequency of domestic radio stations well,
you are suggested to set buzzer as alarm sound.
1. Short press [ALARM] button until " " appears on the top left corner. 2 "B" sound is
heard and the buzzer is already set to be alarm sound.
2. When the alarm is activated, "BB" sound will continuously alarmed. It will turn off
automatically according to your setting.

Snooze

After alarm was activated with buzzer or radio broadcasting, press & release [LIGHT /
SNOOZE] with 1 "B" sound. Then Radio would be turned off temporary, it will start to
www.tecsunradio.com hch@cantonmade.com