Vendor Specific Attribute; Table 53 Supported Vsas - ZyXEL Communications ES-2024 Series User Manual

Table 52 Advanced Application > AAA > AAA Setup (continued)
LABEL
Method
Privilege
Apply
Cancel

22.2.4 Vendor Specific Attribute

RFC 2865 standard specifies a method for sending vendor-specific information between a
RADIUS server and a network access device (for example, the Switch). A company can create
Vendor Specific Attributes (VSAs) to expand the functionality of a RADIUS server.
The Switch supports VSAs that allow you to perform the following actions based on user
authentication:
• Limit bandwidth on incoming or outgoing traffic for the port the user connects to.
• Assign account privilege levels (See
account privilege levels) for the authenticated user.
The VSAs are composed of the following:
• Vendor-ID: An identification number assigned to the company by the IANA (Internet
Assigned Numbers Authority). ZyXEL's vendor ID is 890.
• Vendor-Type: A vendor specified attribute, identifying the setting you want to modify.
• Vendor-data: A value you want to assign to the setting.
Refer to the documentation that comes with your RADIUS server on how to
configure VSAs for users authenticating via the RADIUS server.
The following table describes the VSAs supported on the Switch.

Table 53 Supported VSAs

FUNCTION
Ingress Bandwidth
Assignment
ES-2024 Series User's Guide
DESCRIPTION
Select whether you want to use RADIUS or TACACS+ for accounting of specific
types of events.
TACACS+ is the only method for recording Commands type of event.
This field is only configurable for Commands type of event. Select the threshold
command privilege level for which the Switch should send accounting information.
The Switch will send accounting information when commands at the level you
specify and higher are executed on the Switch.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
the CLI Reference Guide
ATTRIBUTE
Vendor-Id = 890
Vendor-Type = 1
Vendor-data = ingress rate (Kbps in decimal format)
Chapter 22 AAA
for more information on
165