Input Levels
To set levels semi-automatically, display a black pic-
ture from the source computer. Choose Auto Black
Level and press
ENTER
from the source, choose Auto White Level and press
.
ENTER
The Bobcat is now adjusted to the brightest and dark-
est picture this one source can produce. If you
change the computer to a different one, or change
the video card in the computer, you should do this
adjustment again.
LEVEL
Input Levels menu
directly, when the
source is Analog.
. Then display a white picture
key opens the
To set levels manually, display a black picture from the source computer.
Select Manual Black Level and adjust it until one of the three colors just
touches the 0 value. Then adjust the other two colors until they just touch 0
also. Do not push this value "lower" than 0, because the number will not
change, but the picture will get worse.
Now display a white picture from the source computer. Select the White lev-
els and adjust them until the value just touches 255. Do not push them
"higher" than 255, because the number will not change, but the picture will
get worse.
63