Step 2 - Adjust The Input Signal Settings; Select The Source - Clarity WN-5220-V User Manual

Step 2 - Adjust the Input Signal Settings

Select the Source

(The menu with the VIM-200 option installed is pictured here.)
After the displays are all turned on, use this procedure to select the
correct source.
1. Press the remote
2. Press the
15 October 1998
Source Select
Frequency
Phase
Input Level
Position
Zoom
Color Balance
Curtain
Hours
Save Config
Recall Config
Reset Config
Misc Control
About
The Source Select menu is displayed.
control SOURCE
button
Select the type of input source: VGA, Mac II, 31.5K Video,
15.75K Video, Composite Video and S-Video.
Up/Down arrow
keys
Note – The VIM Line Doubler/Scaler card adds 15.75 kHz
Video compatibility. The VIM decoder card adds
Composite and S-Video compatibility.
If RGBS is the source and the format is Sync on Green,
go to the Misc Control Menu and select the Sync on
Green option.
WN-5220-V VideoWall User's Guide
Source Select
[X] VGA
[ ] MAC II
[ ] 31.5K Video
[ ] 15.75K Video
[ ] Comp Video
[ ] S-Video