Direct Station Selection (Dss) - Teleco UST DK User Manual

––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
...or dial a CO Line or
CO Line access code
and then a DISA
security code.
3. Dial a telephone
number.

Direct Station Selection (DSS)

This optional feature enables you to use a
The LED of the button shows the status (idle/busy) of the station and/or the station's [PDN].
For example, a station DSS LED shows busy (light steady red) when the station is:
Busy on a call on any button or is in the DND mode.
Idle, but all appearances of the [PDN] are in use by other stations.
To connect directly to another station [PDN]
"
1. Press
connected to a CO
Line or another
station.
2. Announce the call
...or transfer the call
by hanging up
...or transfer the call
by pressing
#
Features
You hear dial tone.
See the System Administrator for the DISA security
Note
code number. If the correct code is not entered, the call
disconnects.
If set in system programming, both parties hear a warning tone
approximately 4, 10, or 20 minutes after the call was made.
Press to reset the timer each time the tone sounds (for an
additional 4, 10, or 20 minutes). If you do not press
disconnects approximately one minute after the tone.
, while The original party is put on hold. You can call a station even if
the DSS LED shows busy (steady red).
Note You can transfer the call to an idle or busy station.
.
"
button to connect directly to another station.
Direct Station Selection (DSS)
, the call
41