1. Manuals
  2. Brands
  3. Kasda Manuals
  4. Wireless Router
  5. KW58191
  6. User manual

Kasda KW58191 User Manual

Wireless adsl router
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
KW58191 Wireless ADSL Router
User Manual

Advertisement

Table of Contents
loading

Related Manuals for Kasda KW58191

Summary of Contents for Kasda KW58191

  • Page 1 KW58191 Wireless ADSL Router User Manual...
  • Page 2 Wireless ADSL Router USER MANUAL NOTICE This document contains proprietary information protected by copyright, and this Manual and all the accompanying hardware, software, and documentation are copyrighted. All rights are reserved. No part of this document may be photocopied or reproduced by mechanical, electronic, or other means in any form.

  • Page 3: Table Of Contents

    Wireless ADSL Router USER MANUAL Content 1 OVERVIEW ..........................2 1.1 F ..........................2 EATURES 1.1.1 Data rate ..........................2 1.1.2 ADSL Compliance ......................2 1.1.3 Wireless ..........................2 1.1.4 Network Protocol and Features ..................2 1.1.5 ATM Capabilities ....................... 3 1.1.6 FIREWALL .........................

  • Page 4: Overview

    Wireless ADSL Router USER MANUAL 1 Overview Thank you for choosing our product. The KW58191 Wireless ADSL Router uses Broadcom’s CPE solution that fully complies with ADSL, ADSL2，ADSL2+ and IEEE802.11b/g/n standards. It will provide your SOHO with convenient Internet access.

  • Page 5: Atm Capabilities

    Wireless ADSL Router USER MANUAL  Internet Control Message Protocol (ICMP)  IP Static Routing  Routing Information Protocol (RIP, RIPv2)  Network Address Translation (NAT)  Virtual Server, Port Forwarding  Dynamic Host Configuration Protocol (DHCP)  DDNS  Simple Network Time Protocol (SNTP) ...

  • Page 6: Management Support

    Wireless ADSL Router USER MANUAL  Denial of Service Prevention (DoS)  1.1.7 Management Support  Web Based GUI  Upgrade or update via FTP/HTTP  Command Line Interface via Telnet  Diagnostic Test  Firmware upgrade-able for future feature enhancement 1.1.8 Operating System Support ...

  • Page 7: System Requirements

    Wireless ADSL Router USER MANUAL System Requirements Before using this ROUTER, verify that you meet the following requirements:  Subscription for ADSL service. Your ADSL service provider should provide you with at least one valid IP address (static assignment or dynamic assignment via dial-up connection).

  • Page 8: Hardware Description

    Wireless ADSL Router USER MANUAL 2 Hardware Description Front Panel Color Function On: Power on POWER Green Off: No power On: LAN link established and active via LAN port LAN1 Green Blinking: ADSL data activity occurs Off: No LAN link via LAN port On: The wireless module is ready and idle WLAN Green...
  • Page 9 Wireless ADSL Router USER MANUAL Rear panel Port Function Connect the device to an ADSL telephone jack or splitter using a RJ-11 telephone cable Connect the device to user’s PC's Ethernet port, or to the uplink port on user’s hub/switch, using a RJ-45 cable RESET System reset or reset to factory defaults A convenient way for WPS set.

  • Page 10: Hardware Installation

    Wireless ADSL Router USER MANUAL 3 Hardware Installation This chapter shows user how to connect Router. Meanwhile, it introduces the appropriate environment for the Router and installation instructions. Using a telephone line to connect the DSL port of ROUTER to the Modem port of the splitter, and using a other telephone line connect user’s telephone to the PHONE port of the splitter, then connect the wall phone jack to the LINE port of the splitter.

  • Page 11: Pc Configuration Guide

    Wireless ADSL Router USER MANUAL 4 PC Configuration Guide Local PC Configuration in Windows 95, 98, ME, XP 1. In the Windows task bar, click the “Start” button, point to “Settings”, and then click “Control Panel”. 2. Double-click the “Network” icon. 3.

  • Page 12: Local Pc Configuration In Windows Vista

    Wireless ADSL Router USER MANUAL Local PC Configuration in Windows Vista 1. Go to Start. Click on Network. 2. Then click on Network and Sharing Center at the top bar. 3. When the Network and Sharing Center window pops up, select and click on Manage network connections on the left window column.

  • Page 13: Web-Based Management Guide

    Wireless ADSL Router USER MANUAL 5 Web-based Management Guide In order to use the web-based management software it will be necessary to use a computer that occupies the same subnet as the Router. The simplest way to do this for many users will be to use DHCP server that is enabled by default on the Router. 5.1 LAN setting page Launch a web browser, such as Internet Explorer, and then use http://192.168.1.1...

  • Page 14: Pppoe(Ppp Over Ethernet)

    Wireless ADSL Router USER MANUAL From Setup, click WAN, configure the parameters for the channel operation modes of your ADSL Router. 5.2.1 PPPoE(PPP over Ethernet) PPPoE (Point to Point Protocol over Ethernet) provides access control and billing functionality in a manner similar to dial-up services using PPP. The router bridges a PPP session over Ethernet (PPP over Ethernet, RFC2516) from your computer to an ATM PVC (Permanent Virtual Circuit) which connects to ADSL Access Concentrator where the PPP session terminates.
  • Page 15 Wireless ADSL Router USER MANUAL Item Description VPI/VCI Enter the PVC that your ISP gives you. NAPT extends the notion of NAT one step further by also translating the transport identifier (TCP and UDP port numbers, ICMP query Enable NAPT identifiers).

  • Page 16: Pppoa(Ppp Over Atm)

    Wireless ADSL Router USER MANUAL 5.2.2 PPPoA(PPP over ATM) PPPoA stands for Point to Point Protocol over ATM Adaptation Layer 5 (AAL5). A PPPoA connection functions like a dial-up Internet connection. The router encapsulates the PPP session based on RFC1483 and sends it through an ATM PVC (Permanent Virtual Circuit) to the Internet Service Provider’s (ISP) DSLAM (digital access multiplexer).
  • Page 17 Wireless ADSL Router USER MANUAL Item Description VPI/VCI Enter the PVC that your ISP gives you. NAPT extends the notion of NAT one step further by also translating the transport identifier (eg TCP and UDP port numbers, ICMP query Enable NAPT identifiers).

  • Page 18: Bridged

    Wireless ADSL Router USER MANUAL 5.2.3 Bridged With bridging the router has a static IP address for connection. The router passes traffic through to another device (a computer or router for example) that handles authenticating with the ISP. Enter VPI and VCI according to your local region and select the appropriate Encapsulation mode.

  • Page 19: Lan Settings

    From LAN, Configure the DSL Router’s IP Address and Subnet Mask for LAN interface. In this page, you can use DHCP (Dynamic Host Configuration Protocol) to control the assignment of IP addresses on your local network (LAN only).KW58191 support IPv4 /IPv6 dual stack.
  • Page 20 Wireless ADSL Router USER MANUAL Item Description This is the IP address that other devices on your local network will IP address use to connect to the modem. The default is 192.168.1.1. Subnet mask This defines the size of your network. The default is 255.255.255.0. Select this option is to let the device use a second IP on the LAN interface.

  • Page 21: Ipv6 Lan Interface

    Wireless ADSL Router USER MANUAL 5.2.4.1 IPv6 LAN Interface From Setup→LAN →LAN IPv6, Configure the DSL Router’s IPv6 Address for LAN interface.
  • Page 22 Wireless ADSL Router USER MANUAL Item Description This is the IPv6 address that other devices on your local Global address network will use to connect to the modem. The IPv6 RA feature provides support for allowing the network administrator to block or reject unwanted or rogue router RA Setting advertisement (RA) guard messages that arrive at the network device platform.

  • Page 23: Wlan Setting

    Wireless ADSL Router USER MANUAL 5.3 WLAN Setting 5.3.1 Basic Option Description Enable A check box that enables or disables the wireless LAN interfaces. The default is wireless to enable wireless communications. This is the range of frequencies the gateway will use to communicate with Band user’s wireless devices.

  • Page 24: Advanced Settings

    Wireless ADSL Router USER MANUAL isolation Enter a name for user’s wireless network here. SSID stands for Service Set Network name Identifier. This name must be between 1 and 32 characters long. All wireless (SSID) clients must either detect the gateway or be configured with the correct SSID to access the Internet.
  • Page 25 Wireless ADSL Router USER MANUAL Note: After making any changes, click Apply to save. Warning: The settings shown above are default settings. Changes made to these items can cause wireless communication problems. Field Description A threshold, specified in bytes, that determines whether packets will be fragmented and at what size.

  • Page 26: Security

    Wireless ADSL Router USER MANUAL XPress™ Technology is a feature in which two of our devices can communicate with each other at twice the normal rate. XPress™ 54g+ is a technology that achieves higher throughput with frame-bursting. With Technology 54g+ enabled, aggregate throughput (the sum of the individual throughput of each network client) improves by up to 25% in 802.11g-only networks, and up to 75% in mixed networks containing both 802.11g and 802.11b equipment.
  • Page 27 Wireless ADSL Router USER MANUAL 3.Enable WPS as below. 4. Set Start PBC and click Save/Changes. 5.Now you can use a wireless adaptor with WPS function and the WPS button to connect to access the Internet. 6. To configure security features for the Wireless interface, please open Security item from Wireless menu.
  • Page 28 Wireless ADSL Router USER MANUAL secure user’s data while connecting to networks. There are four selections including Open, Shared, 802.1X,WPA, WPA-PSK, WPA2, WPA2-PSK, Mixed WPA-WPA2, Mixed WPA-WPA2-PSK. Different item leads different web page settings. Please read the following information carefully. The wireless security page allows user to configure the security features of user’s wireless network.
  • Page 29 Wireless ADSL Router USER MANUAL encryption method that is not as hard to break as the more-recent WPA. 802.1x — In 802.1x (also known as RADIUS), a separate machine called an  authentication server receives a user ID and password. It grants or denies access based on whether the ID and password match any entries in its account list.

  • Page 30: Management

    Wireless ADSL Router USER MANUAL 5.4 Management 5.4.1 TR069 WAN Management Protocol (TR-069) allows a Auto-Configuration Server (ACS) to perform auto-configuration, provision, collection, and diagnostics to this device. Select Configure TR-069 from Advanced->CWMP. URL: URL for the CPE to connect to the ACS using the CPE WAN Management Protocol. And through ACS (Auto-Configuration Server) you can perform auto-configuration, provision, collection, and diagnostics to this router.

  • Page 31: Port Mapping

    Wireless ADSL Router USER MANUAL making a connection to the ACS using the CPE WAN Management Protocol. This username is used only for authentication of the CPE. Connection Request Password: Password used to authenticate the CPE when making a connection to the ACS using the CPE WAN Management Protocol. This password is used only for authentication of the CPE.
  • Page 32 Wireless ADSL Router USER MANUAL Enable it and select Group1 as below. Set as below.

  • Page 33: Reset Router

    Wireless ADSL Router USER MANUAL Click Apply and you’ll see the following screen. Click Save, Now you can use LAN1 interface for IPTV and other Ethernet interface for internet. Note: If you want to cancel all modification that you do on the Router, please select from “AdminCommit/RebootFactory Default ConfigurationReboot”...

  • Page 34: Appendix Frequent Asked Questions

    Wireless ADSL Router USER MANUAL Appendix Frequent Asked Questions Q: None of the LEDs are on when you power on the ADSL router? A: Please make sure what you use is the power adaptor attached with the ADSL router package，and check the connection between the AC power and ADSL router. Q: DSL LED does not turn on after connect telephone line? A: Please make sure what you use is the standard telephone line (as attached with the package), make sure the line is connected correctly and check whether there is poor...
  • Page 35 Wireless ADSL Router USER MANUAL Q: PC cannot browse Internet web page? A: Please make sure DNS server appointed to the PC is correct. You can use ping application program to test whether the PC can connect to the DNS server of the ADSL operator.

This manual is also suitable for:

Kw58293

Table of Contents