Table of Contents
Advertisement
The hard drive
jumper settings
should be master or
factory default.
Be careful not to
damage any cables
or components and
double check the
connection between
the cables, the
bridge board and
your hard drive
before you close up
the case.
Copyright © 2000-2003 by Macpower Peripherals Ltd. - www.macpower.com.tw
Hard Drive Assembly
Connect the ATA cable and the power line to your hard drive.
Install the hard drive and fasten the screws. Align the top cover
with the body and fasten the screws, before you fit the plastic
cover. Fasten the 4 screws on the back and connect your
power adapter and interface cable.
- 5 -
Advertisement
Table of Contents
