Advertisement
3. Parts and Description
1. Cover: With control panel.
2. Water Reservoir, situated on the rear of the ice maker with cover
3. Evaporator Grid
4. Ice Scoop
5. Water Drain Cap: Quick release
valve to drain water from the unit
6. Ice Basket (stores the ice)
7. Ice Sensor: Stops Ice
production when
Ice Basket is full
Situated just above the
ice basket
6
7
Control Panel
A) Power Indicator Light
B) Power Button (to turn unit on and off)
C) "Add Water" Indicator Light
D) "Full Ice" Indicator Light
3
ADD WATER
FULL ICE
A
ON/OFF
B
4. Operating Procedures & Maintenance
A. Unpacking your Ice Maker
1. Remove the exterior and interior packaging. Check that the Ice Basket
and Ice Scoop are included. If any parts are missing, please contact
our customer service centre.
2. Clean the interior with lukewarm water and a soft cloth. Take out the
basket and clean it.
1
3. Find a location for your Ice Maker that is protected from direct sunlight
and other sources of heat (i.e: stove, furnace, radiator). Place the Ice
Maker on a level surface. Make sure that there is at least 13 cm of
2
space between the back and sides of your Ice Maker and the wall.
4. Allow at least one hour for the refrigerant fluid to settle before plugging
the Ice Maker in.
3
5. The appliance must be positioned so that the plug is accessible.
4
B. Connecting your Ice Maker
5
* Improper use of the earthed plug can result in the risk of electrical shock.
If the power cord is damaged please call our customer service centre.
1. This unit should be properly earthed for your safety. The power cord
of this appliance is equipped with a three prong plug which mates with
a standard three prong wall outlet to minimize the possibility of electric
shock.
2. Plug your appliance into an exclusive, properly installed, earthed wall
outlet. Do not under any circumstances, cut or remove the third (earth)
C
prong from the power cord. Any questions concerning power and/or
earthing should be directed toward a certified electrician.
D
3. This appliance requires a standard 220 ~ 240 volt, 50Hz electrical
outlet with three prong earth.
Before using your Ice Maker, it is strongly recommended to clean it
thoroughly
The ice maker is not designed to be installed in an outside area such as a
garage or a porch. Ambient temperatures of below 10°C or above 38°C will hinder
the performance of the appliance.
DANGER
4
Advertisement
