Harman Home Heating Oakwood Installation & Operating Manual page 15

Fireplace Insert Installation - Rear Flue - 6"Single Wall Pipe
Side Wall
37"(94cm)
26"
(66cm)
NOTICE: Not for use in factory built fireplaces with
hearth weight limitations.
The Oakwood should not be installed into a factory
built fireplace unless the hearth area is designed to
take the maximum weight of the stove. The Oakwood,
loaded with wood weighs approximately 500 pounds
(250kg).
InStallatIOn/ClearanCeS
22" (56cm)
16"
(40cm)
2.75"
(70mm)
Installing in front of a fireplace with Mantel
22"
16"
Mantel: extends over
3/4" from the wall.
Trim: extends less than
3/4" from the wall.
If the fireplace floor can hold the 500 lb. (250 kg)
Oakwood, the stove should only be placed into the fire-
place opening to the point that operation of the damper
bypass control and the top load door operation is not
compromised or unsafe. (See above illustration.)
Combustible
material
non-
Combustible
fireplace
2.75"
non-
Combustible
fireplace
Harman Oakwood
15