Table of Contents
Advertisement
D. PPP over Ethernet
1. Activate WWAN for Auto-Failover: With this function enabled, when the Ethernet WAN
connection is broken, the device will automatically activate the WWAN connection and
keep you connected to internet with the alternative WWAN broadband service. Meanwhile,
if the device detected that the Ethernet WAN connection is recovered, your broadband
connection will be switched to use the Ethernet WAN service
2. PPPoE Account and Password: The account and password your ISP assigned to you.
For security, this field appears blank. If you don't want to change the password, leave it
blank.
3. Connection Control: There are 3 modes to select:
Connect-on-demand: The device will link up with ISP when the clients send
outgoing packets.
Auto Reconnect (Always-on): The device will link with ISP until the connection is
established.
Manually: The device will not make the link until someone clicks the
connect-button in the Status-page.
4. Maximum Idle Time: the amount of time of inactivity before disconnecting your PPPoE
session. Set it to zero or enable "Auto-reconnect" to disable this feature.
5. PPPoE Service Name: Optional. Input the service name if your ISP requires it. Otherwise,
24
Advertisement
Table of Contents
