Westinghouse WP2300 Owner's Manual page 34

TROUBLESHOOTING
PROBLEM
No or low pressure.
Soap does not mix with water spray.
34
POTENTIAL CAUSE
1. Water supply is low.
2. Nozzle is obstructed.
3. Water fi lter screen is obstructed.
4. Water inlet is obstructed.
5. Inlet hose is kinked or leaks.
6. High-pressure hose is obstructed or
leaks.
7. High-pressure hose fi tting leaks.
8. If trying 1-7 above does not solve
the problem, the cause might be
that the pressure washer has a fault.
1. Soap siphon hose is not
submerged.
2. Soap siphon hose is obstructed.
SOLUTION
1. Increase the water supply.
2. Clean the nozzle.
3. Remove and clean the fi lter.
4. Clear the inlet.
5. Straighten the inlet hose and
repair leaks.
6. Clear obstructions in the hose
or replace the hose.
7. Tighten the fi tting. Apply
sealant tape if necessary.
8. Take the pressure washer to
your nearest authorized service
dealer.
1. Insert the soap siphon
hose properly into the soap
container.
2. Clear obstructions in the soap
siphon hose.