Installation Instructions; Figure 4 - Single Monitor Connection - ADEMCO AMM20 Installation And Operating Instructions Manual

20-Inch B&W Monitor

Installation Instructions

WARNING: The monitor should be installed in an area that is
clean, dry and well ventilated. Do NOT install the monitor where it
can get wet; such as near pools, sinks, open windows, etc. Do NOT
install the monitor in excessively dusty areas; dust can block
ventilation holes causing the monitor to overheat. Operate the
monitor on flat firm surfaces; NOT on surfaces such as rugs,
carpet, beds or sofas because these can block ventilation holes on
the bottom of the monitor. Do NOT install the monitor where items
such as drapes or curtains can block ventilation holes. If the
monitor is installed in a rack, make certain it has sufficient
ventilation.
WARNING: If the monitor's plug does not fit your power outlet, do
NOT modify the plug. Have a certified electrician update your
power outlet. Do NOT route the power cord where individuals can
trip on it. Do NOT route the power cord where it can be damaged
such as under a rug.
Place the monitor on a flat sturdy surface near a power outlet. Connect the
video input cable to the Video In BNC connector. The video input can be
from a camera, VCR, multiplexer or the loop output of another monitor.
Figure 4 – Single monitor connection
4
AMM20