Ind Ensor Rientation - WeatherBug Weather Station Installation, Operation And Maintenance Manual

Installing Outdoor Components
7. Secure the three cables below the Sensor Shelter connectors with a wire tie. Form a
drip loop with the three cables (see
Tighten the cable strain relief bracket.
8. Secure the WIND, RAIN and DATA cables to the mast with wire ties.
9. Raise top section of mast and secure in place by inserting bolt(s) through aligned
holes in top and bottom section of mast. Tool-tighten the bolts.
10. Using the compass, confirm that the Wind Sensor's black junction box is still
pointing south. If necessary, lower mast and rotate Wind Sensor so it faces south
(see below).
11. The 200' data cable is now ready to be routed inside the building. Plan your cable
route carefully. Make sure you know exactly where your cables will be before
committing to your route.
IMPORTANT: When routing cables and connectors, be careful not to damage or
strain them. All outdoor cabling must be run in conduit (not included).
AWS-WXN-60003.001
Weather Station Manual
(Continued)
"Connecting Cables to the
W S
IND ENSOR
Version 1.0, Release 5
- 26 -
TRH," page25).
O
RIENTATION
November 2004