Bios Upgrade - AOpen MX4SG-N Easy Installation Manual

14.
10/100Mbps(MX4SG-N) and Gigabits (MX4SG-L) LAN Onboard
On the strength of Broadcom Gigabit LAN controller (MX4SG-L) or Broadcom 10/100Mbps
LAN controller (MX4SG-N) on board, which is a highly integrated platform LAN connect
device, it provides gigabits or 10/100Mbps Ethernet for office and home use. The Ethernet
RJ45 connector is located on top of USB connectors. The right-hand side LED on RJ45
connector indicates Active mode; it shows yellow when accessing to network. The left-hand
side LED on RJ45 connector indicates connecting mode; it lights in orange when 100Mbps
LAN is connected (no light while 10Mbps is connected), and lights in green when gigabits LAN
is connected. To enable or disable this function, you can simply adjust it in BIOS.
15. AOpen Bonus Pack CD
You can use the autorun menu of Bonus CD. Choose the utility and driver and select
model name. After selecting the model name, you can install its INF, Audio, LAN and
USB2.0 drivers from this CD.
Left: Connecting
Orange (100Mbps)
Green (Gigabit)
Right: Active (Yellow)
16. Power-on and Load BIOS Setup
After you finish jumper settings and connect correct cables, power on and enter
Del the BIOS Setup. Press <Del> during POST (Power On Self Test). Choose "Load
Setup Defaults" for recommended optimal performance.

17. BIOS Upgrade

You may accomplish BIOS upgrade procedure with EzWinFlash by the following steps,
and it's STRONGLY RECOMMENDED to close all the applications before you start the
upgrading.
Download the new version of BIOS package
1.
the download BIOS package
(http://www.winzip.com) in Windows environment.
Save the unzipped files into a folder, for example, WMX4SGN102.EXE &
2.
WMX4SGN102.BIN.
Double click on WMX4SGN102.EXE, EzWinFlash will detect the model name and
3.
BIOS version of your motherboard. If you had got the wrong BIOS, you will not be
allowed to proceed with the flash steps.
4. You may select preferred language in the main menu, then click [Start Flash] to start
the BIOS upgrade procedure.
EzWinFlash will complete all the process automatically, and a dialogue box will pop up
5.
to ask you to restart Windows. You may click [YES] to reboot Windows.
Press <Del> at POST to enter BIOS
6.
& Exit Setup". Done!
It is strongly recommended NOT to turn off the power or run any application during
FLASH PROCESS.
Warning: Please avoid of using "Load
Turbo Defaults", unless you are sure
your system components
DRAM, HDD, etc.) are good enough
for turbo setting.
zip file from our official web site. Unzip
(ex: WMX4SGN102.ZIP) with
setup, choose "Load Setup Defaults", then "Save
(CPU,
WinZip