Table of Contents
Advertisement
Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
User's Manual
can be found in the
Bonus Pack
CD. Thanks for the
help of saving our earth.
This Easy Installation Guide x1
80-wire IDE Cable x1
Floppy Disk Drive Cable x1
Serial ATA Cable x1
Registration Card x1
Bonus Pack CD x1
PART NO: 49.8B803.001
DOC. NO: MX4SGI4DN-EG-E0305A
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
Online
5. Connect ATX power cable back to connector PWR2.
1
Normal
(default)
This motherboard provides keyboard / mouse wake-up function. You can use JP28 to enable or disable this
function, which could resume your system from suspend mode with keyboard or mouse installed. The factory
default setting is set to "Disable"(1-2), and you may enable this function by setting the jumper to 2-3.
1. JP14 Clear CMOS
Pin 1
1
Clear CMOS
2. JP28 Keyboard/Mouse Wake-up Enable/Disable Jumper
Tip: When should I Clear CMOS?
1. Boot fail because of overclocking...
2. Forget password...
3. Troubleshooting...
Pin 1
Note: To ensure JP28 wakeup
JP28
function works properly, please go
KB/Mouse Wake-up
to BIOS to enable/disable the S3
S4 KB_Mouse Wake Up
same as the setting onboard.
Otherwise,
Pin 1
function will not act accordingly
Enable
Disable
when suspend mode is activated.
(Default)
item
the
JP28
wakeup
Advertisement
Table of Contents
