Table of Contents
Advertisement
3.1.4 Removing the heat sink
(See Fig.5)
• Prior to performing the following procedure, remove the front
panel assembly.
(1) Remove the two screws C and screw D attaching the heat
sink on the left side of the main body, and remove the heat
sink.
3.1.5 Removing the rear panel
(See Fig.6)
• Prior to performing the following procedure, remove the front
panel assembly and bottom cover.
(1) Remove the two screws E, one screws F and three screws
G attaching the rear panel on the back side of the main
body.
Reference:
During reassembly, before fixing the rear bracket onto the
main body, insert the STEERING cable into the slot.
3.1.6 Removing the main board
(See Fig.7)
• Prior to performing the following procedures, remove the front
panel assembly, bottom cover, front chassis assembly, heat
sink and rear panel.
(1) Remove the two screws H attaching the main board on the
top chassis.
(2) Disconnect the connector CP401 on the main board from
the cassette mechanism assembly.
1-6 (No.49855)
D
Fig.5
Rear bracket
E
Insert steering cables into the slots.
Fig.6
Main board
H
Fig.7
C
Heat sink
G
G
F
E
H
CP401
Advertisement
Table of Contents
