Installing The Software - Bose FreeSpace E4 Series II Owner's Manual

5.0 Using FreeSpace

5.1 Installing the software

Insert the FreeSpace ® Installer™ software CD into the CD tray of
your laptop PC.
If the install program does not start automatically, open "My com-
puter" from the desktop, double-click on the CD-ROM drive icon,
and double-click on the "Setup.exe" icon.
Follow the instructions on the screen to complete the installation.
Programmer's Note: For the Installer™ software to
operate properly, your PC must be connected to the E4
hardware. See the following section, "Connecting to the
E4 system".
5.2 Connecting to the E4 system
To create a design file in FreeSpace Installer™ software, your PC
must have an active connection with the E4 system hardware.
This means that your PC must first be physically connected to
the hardware device with a serial cable and then that connection
must be activated using the software.
1. Connect your PC to the E4 hardware.
Using a serial cable (not supplied), connect the RS-232 serial port
of your laptop PC to the RS-232 serial port on the rear panel of
the E4 hardware.
RS-232 serial data cable
(not provided)
ZONE 1
WALL PLATE CONNECTIONS
1
3
LINE 1
Laptop PC
RS232
E4 system
SENSE MICROPHONES
RS232
ZONE 2 Z O NE 3 ZONE 4
2
MUSIC ON
REMOT E ZONE 4 HOLD/
ON/OF F LINE OUT PBX OUT
4
12V
AUDIO SOURCES
AUX MIC/ P AGE/ MIC/ DIRECT IN /
LINE 2
LINE 3 LINE 4 CONTROL
PTT PTT
Installer™ Software
®
2. Set the E4 rear panel POWER switch to ON.
Verify that the STANDBY indicator is lit on the E4 front panel.
Then press the STANDBY push button to switch the E4 hardware
to the operating mode.
RISK OF ELECTRICA L SHOCK
RISQUE DE CHOC ELECTRIQUE
DO NOT OPEN
NE P AS OUVRI R
RING
E OUT
2
E OUT
OUTPU T
4
VOLT AGE
70V 100V
100/120V~AC T6.25A, L250V
220/240V~AC T3.15A, L250V
DO NOT SWITCH
WHILE POWER IS ON
geprüfte
FreeSpace Model E4 Series II
Sicherheit
400 Watt System Electronics
les. Operation is
ce may not caus e
accept any interference Bose Corporation, Framingham, MA 01701-9168
ndesired operation.
Made in the U.S.A.
STANDBY indicator
AMP OUTPUTS
1 2 3 4
AUDIO SOURCES
1 2 3 4
34 of 80
POWER switch
ON
POWER
OFF
50/60H z
300W MA X
STANDBY push button
SYSTEM
STATUS
STANDBY
DIRECT
INPUT
USB