User Manual
Aolynk DR811/DR814 ADSL2+Broadband Router
& Note:
For DHCP or fixed IP service, the address of the next hop must be entered in the
Gateway box (the box must not be left blank), while Interface can be the default None
or any other value. For other services (i.e. IPoA, PPPoA, PPPoE), either Interface or
Gateway must be specified with a value; if both of them are configured, only Interface
takes effect.
4.7 Security Interface
Click Security in the Main menu and select the Interface tab in the Main Frame to
open the Security Interface Configuration page.
Figure 4-13 Security interface
This page allows you to:
Enable/disable the security.
l
Enable/disable the firewall.
l
Enable/disable the intrusion detection.
l
Assign the security level.
l
Add/delete a security interface.
l
Enable/disable NAT to internal interfaces.
l
NAT configuration.
l
To enable/disable the firewall, click the radio button
corresponding to Firewall, then click the
To enable/disable the intrusion detection, click the radio button
Enabled/Disabled
corresponding
to
button.
25
4 Web-based Management
labeled Enabled/Disabled
button.
Intrusion
Detection,
labeled
then
click
the