Microsoft Windows Nt 4.0; Install Display Driver; Installation Procedures - Asus AGP-V2740 User Manual

IV. Microsoft Windows NT 4.0

Install Display Driver

WARNING! Before installing the ASUS AGP-V2740 series display driver in Win-
dows NT 4.0, make sure that you have installed Windows NT 4.0 Service Pack3
(You must use the same update language of your Windows language available on the
Internet at http://www.microsoft.com/isapi/support/bldqpage.idc? ProductPage=q_servpk).
Otherwise, the system will hang and will not be able to start up!
NOTE: Procedures assume your CD-ROM drive letter is D. To have all the AGP
features, you must be using Windows NT 5.0 (available in the near future).

Installation Procedures

1. Start Windows NT, switch display properties to VGA mode (16 colors, 640 x 480
pixels), then restart your computer to make the change.
2. After your computer restarts, right-click the desktop and click Properties.
3. Click the Settings tab.
4. Select Change Display Type.
5. Select Adapter Type and click Change.
6. Click Have Disk.
7. Insert the ASUS AGP-V2740 Installation CD.
8. Type D:\NT40 or click Browse to select the path of the display driver for Win-
dows NT. Click OK.
9. Select ASUS AGP-V2740 and then click OK.
10. Windows NT will once again prompt for confirmation. All appropriate files are
then copied to the hard disk. When all files are copied, go back to the Display
Properties box by clicking Close. Click Apply.
11. The System Settings Change dialog box is displayed. Click Yes to restart Windows.
12. Windows NT will restart with the default settings. The Display applet will ap-
pear to allow for mode selection.
ASUS AGP-V2740 Series User's Manual 19