Steel City 20530 User Manual page 17

4. Before chuck and spindle installation, make certain that
the spindle taper (E) and the tapered hole in the chuck
(F) are clean and free of grease, lacquer, or rust
preventive coating. SEE FIG. 14, page 14.
Fig.15
H
5. Open the chuck jaws completely. Make sure the jaws
are completely recessed inside the chuck.
6. Seat the chuck onto the drill press spindle as far as it
will go by placing a wooden block (G) under the chuck
(H) and tap the block up with a hammer (I).
SEE FIG. 15.
Important: DO NOT tap the chuck directly with a metal
hammer.
FASTENING DRILL PRESS
Fig.17
G
I
To keep the drill press from tipping, sliding, or walking, it
can be fastened to the floor surface. The machine base
has four holes (A) at the center of the base where it can
be fastened to the floor.
NOTE: Bolts, nuts and washers supplied. SEE page 12 (D).
15
A
A
SEE FIG. 17.
A
A