Assembly - Steel City 20530 User Manual

WARNING
!
The drill press is a heavy machine; two people may
be required for certain assembly operations.
DO NOT assemble the drill press until you are sure
the tool is unplugged from the power source.
DO NOT assemble the drill press until you are sure
the power switch is in the "OFF" position.
For your own safety, DO NOT connect the drill press
to the power source until the machine is completely
assembled and you read and understand the entire
User Manual.
COLUMN, BASE AND
TABLE ASSEMBLY
Fig. 7
C
1. Attach the column (A) to the base (B) using the
four M10 x 40mm hex head screws (C).
SEE FIG. 7.
Fig. 7A
D
F

ASSEMBLY

A
B
E
G
13
2. Loosen set screw (E) and remove ring (D) from the
column. SEE FIG 7A.
3. Place Table Bracket Assembly (F) over top of
column making sure the notch in the side of the
bracket matches up with the rack (G).
4. Replace ring (D) and retighten set screw (E).
Fig. 8
J
H
5. Attach the table raising and lowering handle (H) on
the worm gear shaft (I) and tighten the set screw (J)
against the flat on the worm gear shaft.
SEE FIG. 8.
Fig. 9
6. Thread the stud of the table lock handle (K) into the
hole (L) in the rear of the table bracket.
SEE FIG. 9.
NOTE: On the table bracket, one hole is threaded and
one is not. Insert the stud through the unthreaded hole
and screw into the threaded hole.
I
L
K