Log, Volcanic Stone, And Glowing Ember Placement - Lennox Montebello MDLX40IN Care And Operation Instructions Manual

LENNOX HEARTH PRODUCTS • MONTEBELLO

LOG, VOLCANIC STONE, AND GLOWING EMBER PLACEMENT

NOTE: If installing the Contemporary Burner/Floor
Kit, skip this step and instead refer to the instructions
provided with the kit.
WARNING
• DO NOT attempt to install the logs until the
appliance installation has been completed, the
gas line connected and tested for leaks and the
initial burner operation has been checked out.
• The size and position of the log set was
engineered to give the appliance a safe,
reliable and attractive fl ame pattern. Any
attempt to use a different log set in the
fi replace will void the warranty and will result
in incomplete combustion, sooting, and poor
fl ame quality.
• Logs get very hot and will remain hot up to one
hour after gas supply is turned off. Handle only
when logs are cool. Turn off all electricity to
the appliance before you install grate, volcanic
stone, embers, and logs.
• This appliance is not designed to burn wood.
Any attempt to do so could cause irreparable
damage to the appliance and prove hazardous
to your safety.
• If logs are not installed according to the log
installation instructions, fl ame impingement
and improper combustion could occur and
result in soot and/or excessive production of
carbon monoxide (CO), a colorless, odorless,
toxic gas.
Step 1. Install the ceramic or porcelain panels, per the
instructions provided in kit (refer to document
506019-98).
Step 2. Place volcanic stone around the burner, as shown in
Figure 4.
Step 3. Separate the glowing embers from the larger bag into
pieces about the size of a quarter, as shown in Figure 5.
Mix the glowing embers with the bag of platinum
embers also provided with the fi replace. Keep the pieces
fl uffed, not matted. Distribute these pieces over the
burner as shown in Figure 6. Do not use more glowing
embers than necessary. When properly positioned, the
glowing embers will cover approximately 75% of the
burner for natural gas applications. For propane gas, do
not place any glowing embers on the main ports.
Note: Excessive use of glowing embers may result in sooting
or poor fl ame. This appliance is provided with enough glowing
embers for several applications. Do not use all provided, in one
application. For best glowing effect, replace the ember material
annually. Replacement glowing embers (P/N 88L53) and
platinum embers (P/N H8312) are available.
® DLX DIRECT VENT GAS FIREPLACES (MDLX40/45) • CARE AND OPERATION INSTRUCTIONS
Step 4. Position the individual logs as shown in Figure 7
Cat. No.
88L53
80L42
H8312
Table 5: Firebox Accessories / Parts
Figure 4: Volcanic Stone Placement
Figure 5: Glowing Ember Separation
Figure 6: Glowing Ember Placement
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
through Figure 11 on Page 12. Logs should be placed in
the order shown. Place logs 2 and 3 against the pins
on the grate, NOT over them.
Proper log and twig placement is critical to encourage
outstanding fl ame appearance and prevent sooting.
When positioned properly as shown, twigs will be
positioned between fl ame peaks and will not impinge
any fl ames. Positioning is the same for all colors of
log sets.
Model
FGE
FDVS
PGE
Volcanic Stone
Main Ports.
Glowing Embers
Description
Bag of Glowing Embers
Bag of Volcanic Stone
Bag of Platinum Embers
11