A.O. Smith EWJH 15 User Manual page 9

Conversion From Wall Mounting Installation To Floor Mounting
Step 1: Factory default installation (wall hung)
Step 3: Turn 90 degrees and remove four paper
disks
Step 5: Use four screws (accessories) to fix
the two brackets in place
Step 7: Floor installation
Step 2: Unscrew the four bolts, and remove
the two brackets
Step 4: Place the paper disks to cover the holes
on the jacket
Step 6: Assembly finished depiction
Warning:
The water heater comes with default wall hung
installation. The same should not be used for
floor mounting. Separate floor mounting
accessories have been provided for floor
mounting option.
Note:
Steps 1 through 7 shown above is applicable
for models EWJH 15 and EWJH 25. Similar
steps needs to be followed for EWJH 15 - LHS
and EWJH 25 - LHS.
7