Controlling Receptacles - BayTech RPC-2 Owner's Manual

RPC SERIES OWNER'S MANUAL
RPC SERIES QUICK START (RPC-2 AND RPC-2A)
________________________________________________________________________________

Controlling Receptacles

CONFIGURATION
If the status menu fails to appear, ensure
the correct cables and adapters are being
used and that they are connected properly.
Also, verify the serial communication
parameters are correctly configured.
To set or change the status of the
receptacles, enter one of the following
commands: ON n, OFF n, REBOOT n,
where "n" is the outlet number you want to
command. Entering an outlet number of
"0" sends the command to all outlets.
Reboot only works on outlets which are in
the "ON" condition.
Type "CONFIG" from the RPC> prompt.
The following menu appears:
For the RPC-2:
RPC >CONFIG
1) . . . Change Password
2) . . . Change Outlet Name
Enter Request:
Or for the RPC-2A:
RPC > CONFIG
1) . . . Change Password
2) . . . Change Outlet Name
3) . . . Enable/Disable Confirmation
4) . . . Enable/Disable Status Menu
X) . . . Exit
:
Enter Request
3