Refreshing The Gui Pages; Using The Quick Setup Wizards To Configure The Nss - Cisco Small Business NSS3000 Series Administration Manual

Introduction

Using the Quick Setup Wizards to Configure the NSS

Using the Quick Setup Wizards to Configure the NSS
Cisco Small Business NSS3000 Series Network Storage System Administration Guide

Refreshing the GUI Pages

Although certain GUI pages automatically refresh at a preselected time interval,
some pages do not refresh until they are reselected. The best way to manually
refresh a GUI page is to reselect it through the options in the Manager Menu on
the left side of the GUI window. For example, to refresh the NTP Configuration
page, from the Manager Menu, click Admin and then click Time.
We recommend that you do not use the Refresh button on the Web browser
toolbar as this can cause data issues.
There are three wizards available from the Manager Menu of the configuration
interface. Select the wizard and then follow the onscreen instructions.
•
Initial Setup: Automatically appears when you log into the configuration
interface for the first time. Although you can access it at any time from the
Manager Menu, if you have saved any configuration settings before you run
the wizard, running the wizard will erase any saved data.
For example, if you configure a RAID and then run the wizard, the RAID will
be deleted. The NSS then reboots and the wizard steps you through the
basic configuration to create a RAID, volume, share, user, to set the Home
Directory location, set the time, and so on.
•
IP Camera Options: The FTP and CIFS wizards let you set up the NSS to
store videos from IP surveillance cameras. The type of wizard you choose
depends on the way the camera transfers the video clips.
You only need to run the wizard once and then you must configure
NOTE
each camera to output the video to the configured share.
When running either of the wizards make sure that you create a RAID array,
a volume, and any users that you want to grant access to the surveillance
videos. After running the wizard you must map a network drive to the share
on the PC running the camera utility and configure the camera utility to save
the video to this mapped network drive.
1
3