Assembly And Use For The Single Serve Cup - Ninja BL810 Owner's Manual

Assembly and Use for the Single Serve Cup

ASSEMBLY
Fig. 9 Fig. 10
For best results, use short "PULSES"... Practice makes perfect!!
IMPORTANT: Make sure that the motor base is
plugged in for use.
1 Place the motor base on a clean, dry, level surface
such as a counter or table top.
2 Add ingredients to the single serve cup.
NOTE: Do not overfill! To avoid spilling, do not
add ingredients past the "Max" fill line.
3 Place the single serve blade onto the cup and
screw it on tightly until you have a good seal.
(Fig. 9)
4 Turn the single serve cup upside down and place it
onto the motor base, aligning the tabs on the cup
with the motor base. (Fig. 10) Turn clockwise until
the cup locks in place, the unit is ready for use.
(Fig. 11)
5 Turn the Variable Speed Dial to the Single Serve
icon. The single serve cup only operates at one
speed regardless of which number is chosen on the
dial. Press down on the "Start/Stop/Pulse" toggle
in short intervals to pulse, or push up on the toggle
to run continuously for 1 minute, both at high
speed. (Fig. 11)
If additional blending is desired, push up on the
"Start/Stop/Pulse" toggle for another minute of
blending.
PULSE
Fig. 11
6 When you have reached your desired consistency,
stop the appliance by pressing up on the Start/
Stop/Pulse toggle. Then turn the single serve cup
counter-clockwise (Fig. 12) and pull straight up to
remove. (Fig. 13)
7 Turn the cup upright and remove the single serve
blade by twisting the blade assembly counter
clockwise.
8 Place the Sip & Seal To-Go drinking lid onto the
single serve drink cup, screw on to seal and enjoy!
9 Make sure that the motor base is unplugged when
not in use.
REMOVAL
Fig. 12 Fig. 13
www.ninjakitchen.com
10