Advertisement
A
CTIVE
"The picture on my TV is fuzzy."
1.Adjust the Cable Compensation control on the BVD-10.
This compensates for the increased capacitance on
longer Cat-5 cable runs and sharpens the video image.
"There is hum in the audio signal."
1.Verify that the Cat-5 cable is properly terminated on
both end.
2.Make certain that the system is wired with twisted-pair
cabling.
3.Try turning up the output level on the BVD-10 driver.
4.Make certain there is not a cut in the wiring allowing a
conductor to short to ground (i.e. shield, conduit, cold
water pipe, plenum).
"The sound is distorted."
1.The output level on the BVD-10 may be set too high.
2.The signal level feeding into the unbalanced RCA audio
inputs of the BVD-10 is too high (not likely with con-
sumer grade equipment).
-B
ALANCED
13
Advertisement
