Advertisement
3.2.3 ASSEMBLY/DISASSEMBLY OF [13] MONITOR ASSEMBLY
CAUTIONS
(1) Remove the MONITOR ASSEMBLY from the UPPER
ASSEMBLY first, as they are removed together in main
parts disassembly, and then proceed to the disassembly
procedure.
(2) During the procedure, be careful in handling the LCD
MODULE and other parts. Pay special attention not to
damage or soil the monitor screen.If fingerprints are left
on the screen, wipe them with clean chamois leather or
a cleaning cloth.
Removing MONITOR ASSEMBLY
(1) Turn the HINGE UNIT ASSEMBLY 90°, and remove the
three screws (1-3). Remove the MONITOR COVER AS-
SEMBLY by removing the three hooks (L13a-c).
(2) Pull out the U/D SWITCH BOARD from the MONITOR
CASE ASSEMBLY.
NOTE13a:
During the procedure, be careful in handling the FPC.
(3) Release the lock of the connector (CN13a,b), and re-
move the HINGE UNIT by lifting it up.
<NOTE13a>
FPC
HINGE UNIT ASSY
<NOTE13d>
6
(S13b)
HINGE COVER(L)
<NOTE13b>
Marking in this side.
HINGE
COVER(U)
HINGE COVER(U)
NOTE13b
MAGNET
7
(S13b)
NOTE13c,d
FPC
NOTE13d
HINGE UNIT
MAGNET
(4) Release the lock of the connector (CN13c,d), and pull
out the FPC.
(5) Remove the two screws (4,5), and Remove the MONI-
TOR BOARD ASSEMBLY by removing the hook (L13d).
(6) Remove the two hooks(L13e) and Remove the BACK
LIGHT.
(7) Remove the LCD MODULE.
(8) Remove the SHIELD CASE.
Removing HINGE UNIT ASSEMBLY
(1) Remove the two screws (6,7), and Remove the HINGE
COVER(U,L).
NOTE13b:
During the procedure, be careful in handling the MAGNET.
NOTE13c:
During the procedure, be careful in handling the FPC.
NOTE13d:
The FPC is rolled around the axis of rotation of the
HINGE ASSEMBLY 2.5 rounds (2.5times).
The connecting side to the MONITOR BOARD AS-
SEMBLY is placed inside.
L13b
L13a
MONI.COVER
ASSY
1
(S13a)
2
(S13a)
b
4
(S13c)
NOTE13a
U/D SW
BACK LIGHT
LCD MODULE
S.CASE(LCD)
MONI.CASE
ASSY
Fig.3-2-3
(S13b)
L13c
a
CN13a
5
L13d
(S13c)
MONI BOARD
CN13b
ASSY
a
a
CN13d
d
b
b
c
CN13c
A
L13e
c
BL FPC
d
LCD FPC
A
A
0.248N m(2.5kgf cm)
(No.YF110)1-11
3
Advertisement
