Panasonic KX-TG1611NZ Operating Instructions Manual page 27

TG161xNZ(e).book Page 27 Monday, February 21, 2011 11:03 AM
Programmable settings
Problem
The display is in a language I
cannot read.
Battery recharge
Problem
The handset beeps and/or 8
displays.
I fully charged the batteries, but
– battery level does not increase or
– the operating time seems to be
shorter.
Making/answering calls, intercom
Problem
w is flashing.
Noise is heard, sound cuts in and
out.
The handset does not ring.
Useful Information
Cause/solution
L Change the display language (page 12).
Cause/solution
L Battery needs charging. Fully charge the batteries
(page 10).
L Clean the battery ends (S, T) and the charge
contacts with a dry cloth and charge again.
L It is time to replace the batteries (page 9).
Cause/solution
L The handset is too far from the base unit. Move
closer.
L The base unit's AC adaptor is not properly
connected. Reconnect AC adaptor to the base unit.
L The handset is not registered to the base unit.
Register it (page 30).
L You are using the handset or base unit in an area
with high electrical interference. Re-position the
base unit and use the handset away from sources of
interference.
L Move closer to the base unit.
L If you use a DSL/ADSL (JetStream) service, we
recommend that you contact your DSL/ADSL
service provider to have a DSL/ADSL Splitter
installed. We do not recommend the use of generic
DSL/ADSL filters. Contact your DSL/ADSL service
provider for details.
L Unplug the base unit's AC adaptor to reset the unit
and turn off the handset. Reconnect the adaptor, turn
on the handset and try again.
L The ringer volume is turned off. Adjust ringer volume
(page 14).
27