Getting Started - Kirkland Signature Remote Control 2 User Manual

Getting Started

Charging the Battery
Before using your Remote Control 2, you
need to fully charge the rechargeable bat-
tery. To charge it, plug in the charging cable
as shown below. Then plug the other end
into a power outlet. During charging the bars
in the battery meter will be showing one,
two and three bars continuously. When fully
charged all three bars will be shown.
Turning your Remote Control 2 ON and OFF
To turn your Remote Control 2 ON slide the ON/ OFF switch (1 on
page 8) down to the ON position. A white "I" icon will be visible on
the base of the switch and the display will turn on.
To turn your Remote Control OFF, slide the ON/OFF switch up to
the OFF position.
Do not charge the Remote Control 2 while it is
on your body.
10
Changing programs
The "P" button (10 on page 9) is used to switch between the pro-
grams that your hearing healthcare professional has programmed
into your hearing instruments. The name of the program displayed
can be configured by your hearing healthcare professional. Each
time you press the "P" button the program advances one step, re-
turning back to program 1 at the end of each cycle (e.g. 1, 2, 3, 1).
Each change in program is accompanied by beep tones in both
hearing instruments, if not disabled by your hearing healthcare
professional during the fitting, and the program currently in use is
shown in the display. For optimal performance it is recommended
that both instruments be set to the same program.
Basic
Program 1 'Basic'
Restaurant
Program 2 'Restaurant'
11