Table of Contents
Advertisement
3. HARDWARE SETUP
12) Wake-On-LAN Connector (3-pin WOL_CON)
The WOL_CON connector powers up the system when a wake-up packet or
signal is received from the network through the ASUS PCI-L101 LAN card.
IMPORTANT:
This feature requires that Wake-On-LAN is set to Enabled (see
4.5.1 Power Up Control) and that your system has an ATX power supply with at least
720mA +5V standby power.
P3B-F Wake-On-LAN Connector
13) Wake-On-Ring Connector (2-pin WOR)
This connector connects to an internal modem card with a Wake-On-Ring out-
put. The connector powers up the system when a ringup packet or signal is re-
ceived through the internal modem card. NOTE: For external modems, Wake-
On-Ring is detected through the COM port.
IMPORTANT:
This feature requires that PWR Up On Modem Act is set to
Enabled (see 4.5.1 Power Up Control).
P3B-F Wake-On-Ring Connector
WOL_CON
+5VSB
Ground
PME
WOR
PIXRI# Ground
2
1
ASUS P3B-F User's Manual
35
Advertisement
Table of Contents
