Tpms (Tyre Pressure Monitoring System)* - Activate/Deactivate - Volvo V40 Owner's Manual

Hide thumbs Also See for V40:
Table of Contents

Advertisement

error has occurred in the system. Contact
a Volvo dealer or workshop.
Clearing warning messages
If a tyre pressure message has been shown
and the TPMS warning lamp has been illumi-
nated:
1. Check the tyre pressure on the indicated
tyre/tyres with a tyre pressure gauge.
2. Inflate the tyre/tyres to the correct pres-
sure in accordance with the tyre pressure
label on the driver's side door pillar
(between front and rear doors).
3. In some cases it may be necessary to
drive the car for a few minutes at a speed
above 30 km/h in order to clear the warn-
ing text. At which point, the TPMS warn-
ing lamp is extinguished as well.
Standard in certain markets.
20
NOTE
The TPMS system uses a so-called
compensated pressure value, based
on both tyre temperature and ambient
temperature. This means that the tyre
pressure may differ slightly from the
recommended pressures listed on the
tyre pressure label on the driver's side
door pillar (between front and rear
doors). For this reason, it may be nec-
essary to inflate the tyres to a slightly
higher pressure in order to clear a low
tyre pressure message.
To avoid incorrect tyre pressure, the
pressure should be checked on cold
tyres. "Cold tyres" means the tyres are
the same temperature as the ambient
temperature (approx. 3 hours after the
car has been driven). After a few kilo-
metres of driving, the tyres warm up
and the pressure increases.
WARNING
Incorrect tyre pressure may lead to
tyre failure, which could result in the
driver losing control of the car.
The system cannot indicate sudden
tyre damage in advance.
Related information
Tyre pressure monitoring* (p. 324)
09 Wheels and tyres
TPMS (Tyre Pressure Monitoring
20
System)*
- activate/deactivate
Tyre pressure monitoring (TPMS) (Tyre
Pressure Monitoring System)* warns the
driver when the pressure is too low in one or
more of the car's tyres.
NOTE
The car must be stationary when the tyre
pressure monitoring is activated/deacti-
vated.
Settings are made using the centre console's
controls, see MY CAR (p. 108).
1. Start the engine.
2. Select the system MY CAR to open the
menus for tyre pressure.
Tyre pressure
3. Select
X
> An
is shown in the information dis-
play if the system is activated, the
option disappears if the system is
deactivated
21
.
Related information
Tyre pressure monitoring* (p. 324)
*
Option/accessory, for more information, see Introduction.
09
and press OK.
327

Advertisement

Table of Contents
loading

Table of Contents