Table of Contents
Advertisement
Magnetic zones.
4. Press the button repeatedly until the
required magnetic zone (
1–15
See the map of magnetic zones for the
compass.
5. Wait until the display returns to showing
C
the character
, or hold the button on the
bottom of the rearview mirror depressed
for approx. 6 seconds (use e.g. a paper
C
clip) until the character
is shown.
6. Drive slowly in a circle at a speed of no
more than 10 km/h until a compass direc-
tion is shown in the display, indicating
that calibration is complete. Then drive a
further 2 circles to fine-tune calibration.
7. Repeat the above procedure as neces-
sary.
Menu navigation - combined
instrument panel
The menus shown on the information display
in the combined instrument panel (p. 61) are
controlled with the left-hand stalk switch.
Which menus are shown depends on the key
position (p. 76).
) is shown.
Information display (analogue combined instru-
ment panel) and menu navigation controls.
03 Instruments and controls
Information displays (digital combined instrument
panel) and controls for menu navigation.
OK - access the menu, acknowledge
messages and confirm menu selections.
Thumbwheel – browse between menu
options.
RESET - reset data in the selected trip
computer step and go back in the menu
structure.
If there is a message (p. 106) then it must be
acknowledged with OK in order that the
menus shall be shown.
Related information
•
Messages - handling (p. 107)
•
Menu overview - analogue combined
instrument panel (p. 106)
•
Menu overview - digital combined instru-
ment panel (p. 106)
03
105
Advertisement
Table of Contents
