Pure n Natural Systems PAC-22 H.E.P.A. User Manual

H.e.p.a. air cleaner

PAC-22 H.E.P.A. AIR CLEANER USERS MANUAL

READ AND SAVE THESE INSTRUCTIONS

Pure n Natural Systems, Inc. recommends that a licensed electrician or licensed contractor install

WARNINGS:

1. Always unplug or disconnect the air cleaner from power supply before servicing.

2. To reduce the risk of electric shock or injury to persons, do not expose to water or rain,

do not use in a window.

3. Do not use this fan with any solid state speed control device.

1. Pre Filter

2. Carbon Panel Filter

3. H.E.P.A. Filter

Step 1. The Pre Filter is located behind the intake door (service door). The Pre Filter is a blue and

white polyester, pre-tack filter. The intake door is located closest to the HI/OFF/LO switch on the

face of the system. Unclip the two latches on the intake door and the door will swing down. The

Pre Filter is the first filter behind the intake door. Peel away dirty Pre Filter and discard. Install

the new Pre filter with the white side out. Close door. DO NOT WASH PRE FILTERS.

Step 2. The carbon filter is located behind the Pre Filter. Follow Pre Filter changing instructions

from Step 1. Remove Carbon Filter, discard and replace with new Carbon Filter. DO NOT

WASH CARBON FILTERS.

Step. 3. Remove the adjustable louver door. Remove the H.E.P.A. Bar. The H.E.P.A. Filter is a

pleated media surface with a metal frame. Slip the H.E.P.A. Filter out of the system, discard and

replace with new H.E.P.A. Filter. DO NOT WASH H.E.P.A. FILTER.

Filter maintenance may vary according to each situation.

For any questions, please contact our customer service department at 1-800-237-9199.

units.

Replace every 3 to 4 weeks.

Replace at least every 2 months.

Replace at least every 12 months.

Table of Contents

Do you have a question about the PAC-22 H.E.P.A. and is the answer not in the manual?

Page 1 PAC-22 H.E.P.A. AIR CLEANER USERS MANUAL READ AND SAVE THESE INSTRUCTIONS Pure n Natural Systems, Inc. recommends that a licensed electrician or licensed contractor install units. WARNINGS: 1. Always unplug or disconnect the air cleaner from power supply before servicing.
Page 2 INSTALLATION OF PAC-22 AIR CLEANER EQUIPMENT: 1. Each PAC-22 unit is equipped with two (2) eye bolts, two (2) eye lags and industrial hanging wire for easy installation. 2. The PAC-22 has an eight foot power cord and a three prong grounded plug. Electrical: 120 Volts, 4.2 Amps.
Page 3 SOLID CEILING INSTALLATION OF PAC-22 AIR CLEANER (Installation for 24” on center construction) 1. Remove the system from the shipping container. Remove grill from intake side of the system. Remove filter retainer bar and all 3 filters including pre-filter, carbon filter and HEPA filter.
Page 4 • All electrical components and fan motor are UL Listed and CSA Certified. For any questions, please contact our customer service department at 1-800-237-9199. Pure n Natural Systems, Inc. P.O. Box 1137 ● Streamwood, IL 60107 Toll-Free – 1-800-237-9199 ● Fax – 847-470-1686...