Storing, Recalling, And Erasing Measurement Data; Zones Of 40 Memory - Healthy Living Deluxe Thinline BT-9000HL Owner's Manual

Storing, recalling, and erasing
measurement data
•
Storing data
*After each measurement, the systolic and diastolic
rates, pulse rate and the time & date will be
automatically stored. The memory holds data for the lat-
est 40 measurements in each of 3 memory
zones. If more than 40 measurements are
entered, the memory will automatically clear
out the oldest data.
Recalling data
•
*Press the " " or " " button to select the memory zone.
*Press the "M" button to get your stored memory data. If there is
no data in the memory nothing will appear.
*If there is data in the memory, the first reading will be an average
of the last three recorded set of measurements (systolic and dias-
tolic pressure and pulse rate).
*Press the "M" button again and the latest recorded set of mea-
surements will appear along with the recording time and date.
*Press the " " button to read the next set of stored data. The data
displayed starts with the most recent reading and continues back-
wards to the oldest. Each time a stored memory result is displayed
it will appear for 4 seconds and then the preset personalized level
will appear for 2 seconds. This will continue going back and forth
for 1 minute before the monitor goes into "rest" mode.
*If your memory readings are out of range of your preset personal-
ized levels they will flash as explained on the previous page.
20

Storing, recalling, and erasing measurement data

Storing, recalling, and erasing
measurement data
• Erasing data
*Press "M".
*Press and hold on "MODE" button and then press " " button to
clean all data, the measurement data will be erased.
*To confirm the data has been erased, press the "M" button and no
data should appear.

3 Zones of 40 Memory

When you take a measurement, the monitor automatically stores it in
memory space number one. As you continue to take measurements, the
monitor will push the previous measurement back one space. In other
words, the value in space one will always be the most recent blood pres-
sure measurement taken.
Your monitor features a 3 party memory capability or 3 "zones" - each
zone stores 40 measurements each for a total capacity of 120 measure-
ments. This feature is useful for a user to track their blood pressure
throughout the various periods of the day: morning, afternoon, and night.
Press the "SET" button to toggle between memory zone No.1, 2, and 3.
Once you select a zone that you want to view the measurements in,
press the "MEMORY" button once to view the most recent measure-
ment along with the time and date that it was taken. Press the "MEM-
ORY" button again in succession and you will see all of the measure-
ments registered to that zone. You can then press the "SET" button to
switch to the next zone to view measurements. The monitor will auto-
matically power off after about one minute of inactivity.
*When taking measurements, be sure and select the correct zone
number using the SET button so that the measurement is registered
to the appropriate zone.
Storing, recalling, and erasing measurement data/3 Zones of 40 Memory
21