Ezon SHS-3120 Installation Quick Manual

SHS-3120 Door Lock
Installation Quick Guide Installation Quick Guide
Product Components
Outdoor Body
Dead Bolt Turn Shaft Strike
No. Screw Quantity
1 FH+ M5×20 3
2 OH+ M4×22 2
3 FH+ T4×25 5
4 FH+ M3×6 4
5 FH+ U10-24×9 4
6 FH+ T4×15 4
01
Check the door status
1) You can install the doorlock only when the thickness of it is 1 3/8˝~1 3/4˝(35
to 44 mm). (In case of installing with an auxiliary steel plate, its thickness is
also included.)
2) Check whether the dead bolt and strike can be installed or not. (door distor-
tion, location of the drilling hole, etc.)
Indoor Body Fixing Panel
User Manual /
Magnet Installation Quick Guide Card AA Batteries (LR6)
Description
Out Housing + Plate In Fastening
Out Housing + Deadbolt + Plate In Fastening
Plate In + Wooden Door Fastening
In Housing + Plate In Fastening
Deadbolt, Striker, Iron Door Fastening
Deadbolt, Striker, Wooden Door Fastening
Installation Procedure
1 1
Check the door status
2
2
Perform drilling
3 3
Insert the dead bolt
4
4
Insert the outdoor body
5 5
Connect the fixing panel
6
6
Connect the turn shaft
7 7
Set for the left or right hand
8 8
Check the dead bolt operation
9
9
Fix screws for the indoor body
10 10
Check the door lock operation
02
Perform drilling
1) Check the location and direction of the drilling template sheet, attach the
sheet, and mark on it with a pen. (a, b)
2) Check the location and direction for the dead bolt, attach the drilling template
sheet on the side of the door, and mark on it with a pen.
3) Drill a 1˝(25 mm) hole by using a hole cutter. (a)
4) Drill pilot holes by using a 1/8˝(3.5 mm) drill bit. (c, d)
5) Drill a pilot hole that is within 2 1/8˝ (54 mm) by using a drill bit. (b)
ⓒ
ⓐ
ⓓ
LEFT VIEW
03
Insert the dead bolt
1) Insert the dead bolt from the side of the door.
2) Rotate the dead bolt to adjust the center hole to be horizontally aligned from
outside.
3) Fix the dead bolt by using two 4×15 screws.
Supplied 4x15 wood screws are for a wooden door only. In case of a steel door,
different type of screws are required.
GC68-01188A
ⓑ
FRONT VIEW