Set Up Your First Roomplayer - Simple Audio Roomplayer I User Manual

Set up your first Roomplayer

It's easy to get your first Roomplayer up and running.
Follow the instructions in Steps 1, 2 and 3.
Step 1 Connect your Roomplayer to any
audio inputs or outputs.
Roomplayer I
If you have
Option A. If you have
instructions in
an amplifier), follow the instructions in
apply power until you have completed step 2.
Option A Connect Roomplayer I
loudspeakers and any audio inputs or
outputs.
Connect your loudspeakers using the bare wire terminals
or 4.0mm plugs. To get the best performance, make
sure you connect the red (+) and black (-) terminals from
each loudspeaker to the corresponding terminals on your
Roomplayer. If you incorrectly connect the loudspeakers, no
damage will be done but bass performance will be poor.
(with a built-in amplifier) follow the
Roomplayer II
(without
Option B. Do not
to your
loudspeakers
subwoofer television
How to connect bare wire terminals
If you are using bare wire terminals, push the spring-loaded
speaker connectors on the Roomplayer inward to reveal
the connection hole, insert the speaker wire
into the hole, then release.
How to connect banana plugs
Using a jewelllers screwdriver, remove the central blanking
section of the insulation cover.
8