Electrolux French Door Bottom Freezer/Refrigerator Use & Care Manual page 11

Removing Freezer Drawer
1 Open freezer drawer.
2 Remove drawer screws on right and left sides
(two (2) screws on each side).
NOTE
DO NOT remove center screw from freezer drawer.
This is a factory adjustment.
CAUTION
Drawer is heavy. Use caution when lifting.
3 Lift drawer up and out to remove.
Installing Freezer Drawer
1 With lower slides pulled out, hang drawer onto
slide brackets ensuring pins on each side are
fully inserted into slots on each side.
Drawer
Assembly
Pin
Slot
Fully Extend
Drawer Slides
Cabinet
Removing the Doors
2 Reinstall four (4) drawer screws (two (2) per
side), tighten down, and close drawer (C).
Install Screws
(2) Each Side
3 Check gasket seal around top, bottom, and sides
of freezer drawer.
4 If gasket is not sealed, open drawer and slightly
loosen four (4) drawer screws (two (2) on each
side) to allow drawer to rotate.
5 Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
Push Against
Freezer Drawer
A
6 Tighten four (4) drawer screws.
7 Recheck gasket seal.
8 Install the toe grille by fitting into place.
Grab Drawer
At Center
From Both Sides
Then
Pull Drawer Out
B
11