Disassembly; Tiller Adjustment - Active Care Medical Spitfire 1310 Owner's Manual

For service assistance, please call your authorized ActiveCare dealer.
◊
Caution
•
Make sure you connect all pieces together properly.
•
Turn off all power to your scooter and remove key from key switch to
prevent accident before disassembly.
•
Pay careful attention while assembling to avoid finger injuries
•
Ensure the front and rear sections are set in the right position before
driving.

DISASSEMBLY

You can disassemble the scooter into five pieces: the seat, the front section, the basket, the
battery pack, and the rear section.
Always disassemble or assemble your scooter on a level, dry surface with sufficient space for
you to work and move around the scooter. Keep in mind that the disassembled sections of the
scooter take up more floor space than the assembled scooter.
◊
Caution
To avoid personal injury, ask for assistance, if necessary, while disassembling
or assembling your scooter.
1. Make sure the tiller is raised before reassembling the scooter.
2. Turn key switch to "OFF".
3. Place the free wheel mode lever in the drive position.
4. Pull upward on the swivel-release lever to remove the seat from seat post.
5. Pick up the battery pack and remove it from the scooter.
6. Pull the connecting device upward to the rear section and stand upright.
7. Take off the front section with both hands and lower the shaft.

TILLER ADJUSTMENT

The tiller can be adjusted by the following steps.
1. Turn the knob counter clockwise to unscrew the bolt.
2. Adjust the tiller angel to the desired position; turn the
knob clockwise to tighten the bolt.
Spitfire 1310/1410 Owner's Manual
www.ActiveForever.com
10