Advertisement
Reformer Mode Assembly (continued)
A
B
A & B
C
3. Installing the Carriage Springs:
A. Engage the end of each of the springs which is not color
coded to its respective eyebolt located on the spring anchor
under the carriage. If you have purchased a standard spring set
the springs are best arranged in the following order:
Blue (Light), Yellow (Medium), Blue, Red (Heavy) and then
Yellow
B. Verify that the springs rest on top of the spring support bar
as shown.
C. Place the closed ends of the springs over their respective
hooks on the round spring bar.
4. Installing the Leather Straps (if applicable):
A. Using the clips attached, snap the leather swivel handles
onto the steel rings at the end of the straps.
B. With the spring bar in first gear and the gear block in the
first hole in the track, place the handles over the shoulder
blocks.
C. Thread the loose ends of the straps down through the pulleys
mounted on the cross member at the head end of the TWS
frame (end opposite the foot bar) looping the ends back toward
the carriage. Verify that the strap is not twisted.
D. Unscrew the black knobs on the underside of the carriage
(one on each side of the head rest).
E. Note the holes located near the end of the leather strap. We
suggest that you select a hole that eliminates the slack in the
leather strap. If you prefer a different setting simply select the
commensurate hole.
F. Slide the selected holes over the protruding studs (see photo).
G. Re-assemble the black knobs.
Advertisement
