Advertisement
Adjustable Footbar System
Optional Jump Board & Removable Sidesplit Platform Installation
5
Your Total Workout System
adjustable footbar system. The u-shaped footbar support bar swings
between the legs of the footbar. Position-according to preference-the
footbar support bar on one of the ledges mounted on the inside of the
cross member located at the foot of the TWS.
The two black knobs in the metal bars located on the inside of the cross member
at the foot of the TWS frame are the locking knobs for securing the jump board or
sidesplit platform.
Installing the Jump Board:
1. If using a standard jump board, first position the u-shaped footbar support
bar (the bar that pivots inside the footbar) so it rests on the 2nd position ledge
of the metal bar just in front of the slot into which you will insert the tongue of
the jump board.
2. Insert the tongue of the jump board into the slot between the metal bars and
the wood of the foot end cross member. Make sure that the side of the tongue of
the jump board that has two steel disks is facing the carriage.
NOTE: For safety and warranty reasons the footbar must be used to stabilize
the jump board as shown in the photograph.
NOTE
3. Tighten the black knobs against the steel disks in the tongue. (Remember
to loosen the knobs before attempting to remove the jump board to prevent
damaging it.)
Installing the Sidesplit Platform:
4. Place the footbar in position 4.
5. Insert the tongue of the sidesplit platform into the slot between the metal
bars and the wood of the foot end cross member. Make sure that the side of the
tongue of the sidesplit platfrom that has two steel disks is facing the carriage.
6. Tighten the black knobs against the steel disks in the tongue. (Remember to
loosen the knobs before attempting to remove the sidesplit platform to prevent
damaging it.)
(TWS) comes equipped with a 4-position
®
Advertisement
